[Stromberg 150 CD Carb Coupling or linkages]

2 hours ago, Colin Lindsay said:

That's Andrew Turner Carbs, he's sold two sets recently and has one left. Don't miss these but if you do it might be worthwhile giving him a call; that might just be the ones he has listed, not his entire stock.

Hi Colin - I emailed and managed to grab a set of them.   After a very very long search cannot believe that suddenly three pairs come up!   Anyway thanks you for your input and suggestions - very much appreciated.  Cheers. Mike

[Stromberg 150 CD Carb Coupling or linkages]

4 hours ago, Dave1360 said:

You may have missed them last time, but they're back again:

https://www.ebay.co.uk/itm/353850791946

 

Hi Dave - yes I emailed them - begged a bit and he found another pair and put them on site so that I could buy them - think they have two sets - like buses!   Thank you so much for drawing these t my attention - very grateful and excited to have found them.   Cheers.  Mike. 

[Stromberg 150 CD Carb Coupling or linkages]

Thanks for all of these replies - Dave - exactly correct .......and I missed them!  (definitely a case of snooze, you lose)....  I cannot believe that they were actually up there for sale on Ebay after I had given up looking!    

Paul - I like the look of that arrangement as an alternative.

Will respond to all of these replies / suggestions directly.

Cheers

Mike

 

 

[Stromberg 150 CD Carb Coupling or linkages]

I have recently purchased a pair of refurbished Stromberg CD150 carbs for a Mark 1 GT6.     

Does anyone know where I can find a pair of coupling rods with connectors?   My original ones have nylon connectors and pins but would like to keep the original set as complete and find alternatives for the new carbs.   Diagram attached to show what I am after.  

Any ideas?    Alternative ideas would be appreciated also as I am guessing very difficult to find.

Cheers

Mike

Stromberg Carbs rev 1.pdf

[GT6 Mark 1 Steering Wheel - hornpush mounting assembly unit]

I have a GT6 mark 1 1967 that is almost complete.   Whilst I have a steering wheel (dish type, being refurbished in readiness...) but I do not have the assembly unit that sits over the wheel securing bolt and in which the hornpush sits.   This is a plastic unit about 2" high.   Very frustrating!

Does anyone know of a Mk 1 wheel that might be for sale or from whom I can get the exact dimensions in order to start the process of having one made up (the search is going that bad!)

Photo attached

 

Any hints, clues, help would be very much appreciated

 

Mike