Colin Davies

Has anyone tried or fitted an expansion tank to the GT6 2 litre cooling system. If so did it improve the cooling system? Colin

Much obliged doug.

Can anyone please advise of measurements please? Or if you live in the Bristol or Bath area and have a mk3 gt6 or a late spitfire mk IV or 1500 I could by agreement drop in and make a paper template. Thank you Colin

Yes both, once I get the outer fitted.

Thank you, I can not imagine how six hands would work together, but I know two can't do it. Thank you.

Is is the outer waist seals, have not tried the inner waist seals....yet!

I am experiencing real difficulty in fitting the replacement window seals. Does anyone have any tips or advice to share please?

Thank you all, seems it was not there to be found! I was expecting a hole that would illuminate the inside of the ignition switch, guess I expected too much. I will take the suggestions on board. Colin.

Gt6 mk3

I have fitted a new loom, it has a key light bulb holder. The old loom did not have this, thus far I have not located a hole in which it will mount. Searched all around the ignition switch but not found! Can anyone please advise? Thank you, Colin.

The new boot floor did not come with pre-positioned holes. Measuring and drilling for the fuel tank outlet was quite easy. However looking on the canley classics parts picture the vent appears to go under the fuel tank. Does anyone have measurements for the location please? I can't help thinking the fuel tank may not seat correctly if the exit is under the tank! Should it be on the axle tunnel? I have the same situation for the water drain pipe that runs from the fuel filler neck, where is that supposed to exit, any dimensions please? Thank you, Colin.

Thank you all for your suggestions. The bonnet is now in place the spacing could be improved slightly however I will go back to that later. It now closes without striking either the buklhead or the near side door.

Not yet. I really need another pair of hands to avoid any paint damage. With the current cold spell I have not been able to spend much time in the garage. Arthritis in my fingers is severely limiting progress. I will get back to it once the temperature rises. It has however forced me into completing a number of smaller jobs such as adjustment and fitting rear bumper mounts in the boot area.I I will report progress or not once I can get back to it. Colin.

Thank you Chris. I will give that a try this afternoon. So glad that someone took the time to reply. My target is to eliminate the overlap first then set a gap. I had between 3 and 5mms in mind.