Jump to content

Torque setting for rear trunnion housing to vertical link?


Waynebaby
 Share

Recommended Posts

Hi All,

 

I'm refitting my rear vertical links to the half-shaft trunnion housings on my late Mk3 GT6 and have got to the stage of tightening up the bolt that goes through the bushes. I can't find the torque setting for this bolt anywhere. Haynes tells you to torque it to the correct setting but then doesn't seem to tell you what that setting should be and I've drawn a blank with the Triumph workshop manual. Does anybody know what the correct torque setting would be for the rear trunnion bolt?

 

Thanks

 

Wayne

 

post-995-0-44517000-1481817888_thumb.jpg

Link to comment
Share on other sites

Wayne,

 

I don't have the correct torque figure for that particular bolt and nor do I have a Rolls Royce but I tend to use this link below if the workshop manual does not give a specific torque figure. 

 

http://rroc.org.au/technical/P_Torque_Tightening_Specifications-5098.pdf

 

I know I shouldn't be too far out for general tightening.

 

Regards,

Mick

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...