Jump to content

Herald Lower Rear Quarter Panel Replacement


Bordfunker
 Share

Recommended Posts

As some of you know I am currently rebuilding the back end of my Herald 1200 after discovering a serious lack of metal around the chassis mounts and the lower quarter panel which sits behind the side valance.

 

I have cut out the bulk of the offending metalwork, but have hit a snag.

 

Here's the back of the car as it currently stands.

 

sOzRQd.jpg

 

And here is the replacement quarter panel.

 

AHTwQ0.jpg

 

My problem is the part of the panel that sits behind the light panel, which is in turn sandwiched between the light panel and the boot corner reinforcing piece.

 

Do I cut the repair panel to fit the car as is, and seam weld the panel where it would normally sit between the other panels?

 

Or, do I have to remove the reinforcing piece to gain access to in turn remove the remnants of the old quarter panel?

 

Has anyone else done this? If how did you do it?

 

Thanks

 

Karl

Link to comment
Share on other sites

  • 2 weeks later...

After a bit of poking around the boot reinforcing plate I identified a number of very small spot welds holding the remains of the side panel in place.

 

You can see them drilled out here.

 

Getydd.jpg

 

This left one remaining spot weld at the bottom of the light panel, which I sliced out with a wood chisel, and a sharp blow from below.

 

zFA8JR.jpg

 

Hopefully that may be of help someone in the future facing the same task.

 

Karl

Link to comment
Share on other sites

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...