Jump to content

Funny Pinion Nut


Mad4classics
 Share

Recommended Posts

OK, leaking pinion oil seal.

Spitfire Mk3 with FC numbered axle.

Got fed up with topping up the diff and mopping the floor; it's getting so it sprays a line of oil under the car.

Instead of a castle nut and split pin (or a nylock which it shouldn't be on an FC diff ?) uncovered this sort of double castle nut with no split pin and no visible hole for one. Not seen a nut like this before!

What's the best way to tackle this; still mark and return to original position? or find WM torque figure?

David

image20181229_114318220.jpg

Link to comment
Share on other sites

Thanks Pete,

Spotted the single split pin hole now (after a bite to eat and a cupa) no split pin in it though! NOT FITTED.

Was expecting a "standard" castle nut.

My Unipart WM doesn't give a torque figure for the pinion nut, doesn't seem to differentiate between solid and collapsable spacer, just says mark and return. Intereurope manual gives 90-100; does that sound right? Is it then on to next castle nut position?

David

image20181229_132755944.jpg

Link to comment
Share on other sites

Hardest part  has been getting the old seal out.

New seal somewhat thinner; is it best to drive fully home or flush with face?

David

Ps. now found a new way to drain diff as no drain plug; but you get a soggy sleeve and EP90 isn't a substitute for Brylcreem! Not that I've got that much hair anymore.

image20181229_150426423.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...