A TR7 16V Posted July 3, 2021 Report Share Posted July 3, 2021 Not entirely sure if this is bodywork not engine, but close enough I hope. So is there anything I'm missing about taking the Herald's engine bay side panel out with the rad in place, like something that make it easy? Graham Link to comment Share on other sites More sharing options...
Pete Lewis Posted July 4, 2021 Report Share Posted July 4, 2021 no its a shove push pull there it goes getting it off the turret and past the odd few brackets is not a dark art just a bit of perseverance Pete Link to comment Share on other sites More sharing options...
Badwolf Posted July 4, 2021 Report Share Posted July 4, 2021 I fabricated some new side valences for the Spit, from ali sheet. Still not fixed them. Everytime I try to work them around everything to put in position before fixing them I end up thinking "Am I bovered"!! Link to comment Share on other sites More sharing options...
A TR7 16V Posted July 4, 2021 Author Report Share Posted July 4, 2021 Oh well. Thanks anyway. It's not a job I do often. I was only looking for an easy way to access the bottom bolt on the steering knuckle (mine is) cos it's a bitch to get at. But while it gives wonderful access once the panel is off, the whole job is still a bit hard. Graham Link to comment Share on other sites More sharing options...
Pete Lewis Posted July 4, 2021 Report Share Posted July 4, 2021 have you looked at going from down under safely supported with extension and socket etc Pete Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now