John1500Spit

Thanks very much. It's now working again, but accessing the bolts was a nightmare. There must be an simpler way to get at them. Is there anything that makes it easier (for when I replace the whole unit)? Appreciated the help.

Thanks for those. One side is a little loose so I'll try tightening it up first to see if that does anything. If not, I'll see about taking it off. A job for after dinner I think. Let you know the results. Thanks again.

Noticed these had stopped working at the weekend. All other lights are fine. So are the bulbs. So I decided, with the help of the Haynes manual to remove the whole lamp to check the wires behind were OK. The manual shows its fixed to the bodywork with screws but it isn't, it looks like two round bolts (hopefully pic attached). ???? Any suggestions on how to deal with this? I haven't tried pliers yet. Thanks in hopeful anticipation.