Gadgetman Posted October 13, 2018 Report Share Posted October 13, 2018 Does any one know the purpose of the bolt hole in the distributor pedestal casting in the 1600 block it just takes a 7/16 unk x 1/2” blanking bolt. ?? Link to comment Share on other sites More sharing options...
JumpingFrog Posted October 13, 2018 Report Share Posted October 13, 2018 I suspect this is where the drilling for the third main was done (or some other oil feed). Never worked on a 6-cylinder, but on a 4-cylinder a drilling from here goes across to meet up with the angled drilling from the centre main bearing holder. Side note, watch the gangs of drills in this video (9:07), fascinating stuff showing a Morris engine being made. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now