Andrew
-
Posts
353 -
Joined
-
Last visited
-
Days Won
8
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Store
Events
Posts posted by Andrew
-
-
Just tighten and feel the washer spread and that is enough. The rest is garbage
Andrew
-
I remember Richard at service motors
Andrew
-
I replaced my courtesy light switches from James paddock, look just like originals and work well
Andrew
-
Yes agree with Pete just apply dry no sealer required mine has been on for a few years now and no Leakes at all
-
Count me in for any twiddle days
Andrew
-
I have a 1360 herald and I am sure my prop shaft is solid no sliding joints or straps am I correct is there such a thing
-
If I were you I would buy the luminition unit from club shop. It transformed the performance in my Herald.
-
First of all but from club shop to support our shop. Second you do not need any sealant on a rubber gasket. I fitted mine at least three years ago and no leaks
Andrew
-
What exactly do you need to know
andrew
-
Thanks guys will visit the shop
-
Do silicone hoses shine to much or should I have said look to shiny
-
I intend to keep my car as it was one of the last of the production line. It is completely standard and I want to keep it that way. I will visit the club shop and invest in a set of silicone hoses
Andrew
-
Hello guys and girls. It is time to renew my hoses on my 1360. Are silicon hoses worth the money.
regards
Andrew
-
What car are we looking at Colin
-
Out of curiosity did a new drain plug come in the filter box
-
Did you buy the exhaust from the club shop. The reason I ask I bought mine from the shop and all the fitting were in the kit so very simple to fit. Tell us more of the fittings from front to back.
mine has a clamp on the bell housing then a rubber strap on the chassis at the back.
Andrew
-
Thanks for your advice
-
Have you tried TD fitchet
-
Hello. How do you grease UJs on my output shafts. I have just noticed that there are a blanked of grease nipple point on both the UJ but how do you get a grease nipple in there. Can you but long nipples for this and if so where can I get them from.
regards
Andrew
-
Are you saying it is there to warm up the inlet manifold so the air entering the engine is pre warmed. Sorry to be dense.
-
Can I ask a stupid question. On my 13/60 why does a water pipe run to my heater matrix through the inlet or is it the exhaust manifold what is the purpose of this layout.
andrew
-
Should there
be a flat side on the dash hole and on the switch to stop it turning
-
Ok get that I just though I was going senile
-
Thank you both. That is my job for the Easter weekend.
Rear diff oil seal.
in Drivetrain & Rear Axle
Posted
Hi
Did my seal a few months back.
Count the turns of the nut.
Remove oil seal with seal remover leveror a screwdriver.
Apply lock tight
Tighen nut back up and of course count the turns
Torque up as recommended
Job done