Flemming Posted March 11, 2016 Report Share Posted March 11, 2016 Hello Is it possible to remove the 1/4 shafts for bearing/seal replacement without to have to completely remove the 1/2 shafts. According to WSM and Haynes for that matter it isn't; but some of you guys may have experienced it other ways? regards, Flemming Link to comment Share on other sites More sharing options...
Pete Lewis Posted March 11, 2016 Report Share Posted March 11, 2016 Yes just need to allow the shaft to drop out the way to allow the short shafts out Undo the socket screws by putting allen key through the coupling bolt holes getting the bearings off the shaft is the hard bit, can be very difficult pete Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now