Spitfire 1500

[Chris Bracey]

hi. I want to route the temp sensor for a dual oil/water gauge and will fit it where the current temp gauge is fitted. I cant see an obvious route without making a hole in the bulkhead. Any suggestions?

[Colin Lindsay]

The large grommet around the wiper rack shaft is usually large enough to slip an additional cable / pipe through; on my GT6 that's the way I route the pipe for the oil pressure gauge.

[yorkshire_spam]

Are you wanting to route it down the left or right of the vehicle? On the right (uk drivers side) there's the Speedo drive hole, wiper rack shaft, wiper loom and washer pipe holes. Down the left there's the hole for the main loom through the bulkhead just below the solenoid - that's were I routed the pipe for my oil pressure gauge.