Chris Bracey Posted July 15, 2020 Report Share Posted July 15, 2020 hi. I want to route the temp sensor for a dual oil/water gauge and will fit it where the current temp gauge is fitted. I cant see an obvious route without making a hole in the bulkhead. Any suggestions? Link to comment Share on other sites More sharing options...
Colin Lindsay Posted July 15, 2020 Report Share Posted July 15, 2020 The large grommet around the wiper rack shaft is usually large enough to slip an additional cable / pipe through; on my GT6 that's the way I route the pipe for the oil pressure gauge. Link to comment Share on other sites More sharing options...
yorkshire_spam Posted July 15, 2020 Report Share Posted July 15, 2020 Are you wanting to route it down the left or right of the vehicle? On the right (uk drivers side) there's the Speedo drive hole, wiper rack shaft, wiper loom and washer pipe holes. Down the left there's the hole for the main loom through the bulkhead just below the solenoid - that's were I routed the pipe for my oil pressure gauge. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now