Jeffds1360
-
Posts
1,382 -
Joined
-
Last visited
-
Days Won
5
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Store
Events
Posts posted by Jeffds1360
-
-
Can you get the barrel out?
Maybe that is replaceable ?
-
Blimey! 10 quid over here. E.G. below. Your later one cannot be much different??
-
Do the spits not have a reinforcing bar/struts? It looks very posh. Heralds have bars but not like that.
Yes RTB, good idea! A Tuxedo can hang there and you can do an 007 or milk tray man 'change'
-
Either a cloths rail or for smoking kippers on ??
-
1
-
-
Unlikely. Performance would suffer.
Wash it down with 'gunk' or similar.
Scatter talcum powder all around. Have a drive and look for rivulets. Probably rocker gasket ??
-
Wow! That looks 'warm' !
Hopefully just some oil leakages getting burnt off. ??
-
Yes, I got a pump from ☆immers and it ran at 7 psi. Lost 1/2 gallon before I realised! I complained and they sent me another. Exactly the same.
I cleaned and reused the original !
The actual problem was air leaking in from the pick up pipe!
-
Now now boys
I only started this to show my 'mess'
Must get some cable ties and maybe a fuse box behind the radios.
Damn that handbrake! Keep catching my belt hooks on it
pity my neuralgic fingers cannot grip and strip.
-
Pulled the (original) radio out to piggy back a FM/Cassette player and found this mess.
Most of my own doing ( done by 'feel' over the last couple of years.
Not scotchlock in sight, plenty of fuses!
-
360 ft/lb is 500 Newton metres but CATTLE???. One up on horses I suppose... must be Argentinean origin? Fray bentos?
Certainly will be frayed and bent being made of plastic !!
-
Thank you.
Not a fuse then? or does it act as one too?
I'll fit one anyway. Cheers.
-
Just popped the fuse holder to check ampage...
Found this!!! Any idea what it may be?
I'm piggybacking a cassette/ FM radio to it. Pity I only have mono speakers:)
-
What are you going to do with the Mk2 seats now?. Hint hints nudge nudge
-
What about this stuff? Only about £17 a gallon
-
Tom, if yours has the Ash tray in the central top position, I found that very handy. For the others, I used the demister duct.
-
I mentioned the GEM in a post a few months back (something I resigned from recently) I had been with them since they were Vintage.
No one even attempted a reply so I guessed they are a 'banned' subject ???
-
That is odd! Ours are green for general waste, brown for garden waste and grey for recycling. Simples
-
Classic car meet at Backworth Hall on Sunday 5th June 2022. 11am- 4pm. £5/car. Organised by MG car club. Anyone?
Don't get many up here!
-
Que ? No coprendo!
-
I've just had a quick peek under my bonnet and I seem to see a full inch clearance from the rear of the arch to the bulkhead 'ledge' ..... ???? As I shut bonnet, about 6" to go before shut.
Mind, it was by torchlight, but no way would it touch.
-
Like my grandson said "it's got a choke???"
I've slightly reprofiled the cam to give faster tickover at 1/4 choke. Never needed more than 3/4 when 5 degrees +. Started today at 14 degrees outside with half but in a few seconds, non required
Here's a piece of mine at off
-
Good evening and welcome. You have taken on some 'project' there!
Good luck.
-
Not really followed this but saw the request so here goes. Lighting poor only got a dangle single bulb:)
If you need more I'll get out in the sun tomorrow
-
I studied your video and the smoke seems to start lower down. Mind I have a slight cataract too
Good luck duck, I mean Quack. You need a knowledkableowledge ??? What??* predictive
Where abouts down South are you Local group may have a guru.
Different engine
in Engine
Posted
Maybe fuel starvation?
Seems to be a lot of it about..
E10 ? Rubber slivers? Crud in float Chambers? Fuel pump woes?