ahebron Posted June 14, 2020 Report Share Posted June 14, 2020 Good afternoon Can some one please tell me the open and closed dimensions for the Vitesse/Herald boot lid support bracket Possible source for these ishttps://www.comac.co.nz/lid-stays-support-stays support stay with safety catch. Section K has what looks like the boot catches for our cars and section N has the glove box latch. Thanks Adrian . Link to comment Share on other sites More sharing options...
Colin Lindsay Posted June 14, 2020 Report Share Posted June 14, 2020 I nipped out and measured an unfitted one; when closed up, right angled bracket end to right angled bracket end is 358mm. It extends out fully to 625mm but then drops back to locked position which is exactly 600mm. The right angled mounting brackets obviously pivot so I set them to exact right angles at either end, both horizontal to a vertical stay. Link to comment Share on other sites More sharing options...
ahebron Posted June 20, 2020 Author Report Share Posted June 20, 2020 Fitted my support from Comac, 1735 Length was a 100mm shorter than your measurements Colin and the boot is nearly vertical. I had to remove the bottom rivet securing it to the bracket to swap sides and I also cut the bracket down to fit behind the lower support bracket plus give it a wee band to sit at a similar angle to the top one. Including freight it was NZ$39 Adrian Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now