PPP 368H

[VixenPPP]

Hi all..Can I appeal for some help please. It's basic wiring for the O/D solenoid. I have a new relay, wiring loom and I've amazed myself by fitting a new solenoid. With the help of Pete Lewis with the 2 page guide. I have power from ignition and battery to the relay. I dare not try and wire it myself. It's on axle stands and the engine will start and I have a pit which I don't think will be needed. I've been let down twice. It's very frustrating. I'm at Shepshed in Leicestershire.

......Neil

[Pete Lewis]

 

its too hot to go looking for a scan but steves WSM on line for vitesse has the basic D type wiring 

http://vitessesteve.co.uk/Servicemanuals

pete

[VixenPPP]

Hi all...An auto electrician looked at the wiring on PPP, but, he's away now. Anyway , looking at how he's left the wires it doesn't look too difficult. This was before I fitted the solenoid. It may be obvious to most, but, the yellow wire that's cut needs to be connected to the one next to it with the spade connector ?Would I use bullet connectors ?You'll notice the new relay . I'll post pics of the other wires down to the sol etc later.

Thanks...Neil

[Pete Lewis]

you could use a crimp on male lucar 

aldi were doing a set with splicers pliers last week with a selection of all sorts 

a bullet will work if thats what  you have  

Pete