Classicscrap Posted May 3, 2020 Report Share Posted May 3, 2020 Hi, I have fitted the bonnet on my Herald so that I can get all the panels aligned before I paint it. Unfortunately a previous owner has cut both of the bonnet stiffeners (items 12 and 13 on the parts diagram. These are no longer available to buy so I will need to repair the existing ones. Could anybody please let me have some dimensions of the original ones? Thanks in advance, Brian Link to comment Share on other sites More sharing options...
Colin Lindsay Posted May 3, 2020 Report Share Posted May 3, 2020 Not easy to get at, but I've measured the top (longer) side as 150mm, allowing for the bit that is in behind the other panel; lower edge is 120mm and it's 60mm wide. All approximate as the tape is bent at all kinds of angles trying to get in there, but it's as close as I could get it. It will be the same width as the bracket it attaches to on the support tube, allowing for the overlap around the edges. Link to comment Share on other sites More sharing options...
Classicscrap Posted May 3, 2020 Author Report Share Posted May 3, 2020 Colin, that’s perfect. Thank you so much for doing that. Brian Link to comment Share on other sites More sharing options...
PeteH Posted May 3, 2020 Report Share Posted May 3, 2020 Hi I am working on mine; Hope these may be of some use? Pete Link to comment Share on other sites More sharing options...
Classicscrap Posted May 9, 2020 Author Report Share Posted May 9, 2020 Thank you Pete. Mine have been cut off just before the two bolt holes, so I should be able to extend them by the right amount now. Brian Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now