1972 GT6 Headlights loom route - chassis to bonnet

[Aidsaunders]

Can anyone send me pictures of the loom route from chassis to bonnet. I’m assuming that it’s something like in the picture. The protection sleeve would be held by the clip welded to the chassis and I’ll cable tie it to the bonnet hinge tube. It does end up neatly laid on the top of the c member when the bonnet is down and doesn’t snag anywhere. 

[johny]

Pretty certain it crosses to bonnet on near side and then all lays in the nose of the bonnet with a great pile of bullet connectors in the middle. That way it doesnt have to run across the front chassis rail....

[chrishawley]

Just a photo scaveneged from an advert. But it's correct with the headlamp wiring loom running up the left bonnet tube held by two metal clips. These clips often go missing and are not easily obtained.

[Stratton Jimmer]

My loom is a little different in that it exits the bulkhead adjacent to the front of the nearside engine bay valance, runs along the valance and then to the offside along the front chassis member. Here a return line runs back to the centre of the chassis member to feed the headlights. Hopefully these pictures will make it clear. Mind you, these are most likely not the original routing.

Edited October 1, 2023 by Stratton Jimmer
Misspelling.