aeroroger Posted March 27, 2015 Report Share Posted March 27, 2015 I would like to add a voltmeter to the dash of my GT6 mark 3 preferably to the section around the left hand air vent. I can feel that there is already a hole cut behind the facia how easy is it to remove this left hand facia? Aeroroger Link to comment Share on other sites More sharing options...
Dick Twitchen Posted March 28, 2015 Report Share Posted March 28, 2015 Roger, Assuming the arrangement is similar to a Mk1, and my memory is not failing me, not too difficult but you need to undo and move to one side the centre section of the dashboard to get at all the retaining screws. I fitted my extra dials in a panel on the dash support pad behind the gear lever (where the radio stowage normally is) and put the radio under the passenger shelf. Dick Link to comment Share on other sites More sharing options...
dougbgt6 Posted March 28, 2015 Report Share Posted March 28, 2015 I have seen people actually use the air vent for a dial, the ventilation system being practically useless you might as well! But like Dick I put extra gauges on a panel in the radio slot. It looks pretty good, like it's supposed to be there. I managed to get a radio to fit on the driver's side "parcel" shelf. Yes. there is one Probably more correctly described as an envelope shelf. Link to comment Share on other sites More sharing options...
dougbgt6 Posted March 28, 2015 Report Share Posted March 28, 2015 Here's a picture. The Black vinyl frame is a bit mucky but I've cleaned that up. Honest! Link to comment Share on other sites More sharing options...
Colin Lindsay Posted March 28, 2015 Report Share Posted March 28, 2015 I think there are only two nuts holding that section of dashboard on (the passenger side triangular bit?) - put your hand up behind after removing the glovebox and you’ll feel the nylon nuts over the threaded mounts which are screwed to the back of the wooden fascia. There is already a hole in the metal backplate, which if you’re lucky will have shaded / coloured the backing of the dash after all these years so will show you where to cut the wood. In my Mk3 I had a clock there, but also had three additional dials in the radio cut-out which are easier for the driver to see. Link to comment Share on other sites More sharing options...
aeroroger Posted March 28, 2015 Author Report Share Posted March 28, 2015 Thank you all for your helpful input.Now I can proceed with some confidence. Aeroroger Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now