Vitesse Saloon inertia reel seat belts MGF seats

[ahebron]

I suppose the title says it all but will inertia reel seat belts fit in a Vitesse Saloon with MGF seats?
Just want to know if the reel interferes with the seat sliding back as far as it can go.

[Paul H]

Yes the inertia belts will fit . I have MGF seats In my Vitesse saloon . I can send a pic later on today to show the clearance 

Paul 

[martyn wright]

Hi!  If you look under "Bodywork & Fittings"  My 1600/6 Seatbelts!  There are 185 comments I am sure you will find something!

[Pete Lewis]

the only close/foul up i had was fully rearward could dig in the prop tunnel carpet 

i used some spacers to raise the runners 

but its nowhere near the reels at the B post base /rear kick board zone 

[Paul H]

Here’s my MGF seat setup in my Vitesse Saloon 

seat fully back no interference (only just )

seat fully back , inertia belt position inclined to rear , no interference

Rear right post , aluminium spacer tube , can measure if you want 

rear left post , wiring is for heated seats 

front posts  , half of rear posts , again can measure if you want 

I used the original seat holes and have the instructions for conversion somewhere 

Paul 

 

 

[Pete Lewis]

and a word of warning do not envisage using the mounts on the MGF seats as the seat floor fixing is not 

up to the job unless you do some serious beefing up          in a crash you could exit the car on the seat  .

Pete

[ahebron]

Thanks for the photos all.
My seats are on 30mm x 3mm SHS so nice and strong and not too high that my head is in the roof.
No worries about me using the MGF seat belt fixing as I do not have them and would no consider using them if I did.
Paul H I like the seat belt retaining strap on the headrest