ahebron Posted February 25, 2022 Report Share Posted February 25, 2022 I suppose the title says it all but will inertia reel seat belts fit in a Vitesse Saloon with MGF seats? Just want to know if the reel interferes with the seat sliding back as far as it can go. Link to comment Share on other sites More sharing options...
Paul H Posted February 25, 2022 Report Share Posted February 25, 2022 Yes the inertia belts will fit . I have MGF seats In my Vitesse saloon . I can send a pic later on today to show the clearance Paul Link to comment Share on other sites More sharing options...
martyn wright Posted February 25, 2022 Report Share Posted February 25, 2022 Hi! If you look under "Bodywork & Fittings" My 1600/6 Seatbelts! There are 185 comments I am sure you will find something! Link to comment Share on other sites More sharing options...
Pete Lewis Posted February 25, 2022 Report Share Posted February 25, 2022 the only close/foul up i had was fully rearward could dig in the prop tunnel carpet i used some spacers to raise the runners but its nowhere near the reels at the B post base /rear kick board zone Link to comment Share on other sites More sharing options...
Paul H Posted February 25, 2022 Report Share Posted February 25, 2022 Here’s my MGF seat setup in my Vitesse Saloon seat fully back no interference (only just ) seat fully back , inertia belt position inclined to rear , no interference Rear right post , aluminium spacer tube , can measure if you want rear left post , wiring is for heated seats front posts , half of rear posts , again can measure if you want I used the original seat holes and have the instructions for conversion somewhere Paul Link to comment Share on other sites More sharing options...
Pete Lewis Posted February 25, 2022 Report Share Posted February 25, 2022 and a word of warning do not envisage using the mounts on the MGF seats as the seat floor fixing is not up to the job unless you do some serious beefing up in a crash you could exit the car on the seat . Pete 1 Link to comment Share on other sites More sharing options...
ahebron Posted February 25, 2022 Author Report Share Posted February 25, 2022 Thanks for the photos all. My seats are on 30mm x 3mm SHS so nice and strong and not too high that my head is in the roof. No worries about me using the MGF seat belt fixing as I do not have them and would no consider using them if I did. Paul H I like the seat belt retaining strap on the headrest Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now