Paul H
-
Posts
3,107 -
Joined
-
Last visited
-
Days Won
27
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Store
Events
Everything posted by Paul H
-
If you meant the pump I thought it had to be horizontal Paul
-
Vertically as has a ball bearing in the top . In a crash the ball bearing pops out and breaks the power Paul
-
Bolted to the side panel by the battery . Wired inline on positive side and protected by 10am fuse Paul
-
I didn’t fit a relay though it’s has a 10am fuse . From memory it uses 5 to 8 amps Paul
-
Yes I have installed an inertia switch from I think a Peugeot . Looks like this pic Paul
-
I have the HUCO 13001 fuel pump and can recommend it Paul
-
The choke on my CDSE’s is on the front carb . Is this wrong ? Paul
-
-
I see you have a dished steering wheel , although I have MGF seats in a Vitesse Saloon ( more access ) i also have a 13" flat steering wheel , changing should give you more room ? Paul
-
In addition to jacking the sump i loosened the offsite engine mount . Paul
-
https://www.rust.co.uk/?s=Tank+repair&post_type=product https://www.frost.co.uk/fuel-tank-repair/ i used frosts tank liner expensive though it worked . You must follow the instructions to the letter . I would go for Rust with slosh . Rust has a good reputation Paul
-
http://www.tdfitchett.co.uk/ Paul
-
Has anybody fitted one of these to a smiths heater ? Paul
-
Another vote for Lidl impact wrench . Mine is 240v and cost £30 a couple of years ago , prices have risen though still worth the money Paul
-
Hi Colin the 3/8 threaded bar . This if AF ? Paul -
Hi Phil , re extraction didn’t know if there was an explosion risk with the blower and vapour / motor sparks Paul
-
Thanks Pete I am using an HVLP gun though some of the overspray will be down to my in experience Paul
-
Hi Phil . Thanks for advice and the comments preferring extraction over pressurising as I might be able to do this . My setup is an SIP oil free compressor which is low noise 57db with Deviblis entry level HVLP gun currently set at 28psi. I’m sure a lot of the overspray ( turns into paint dust and currently settling everywhere ) is down to my inexperience . Perhaps an obvious ? Can your air mover safely be used for extraction as well as pressurising . Paul
-
This is my solution for my Vitesse using a s/h Hoover pressure switch Paul
-
Hi Phil . With your spray booth set up does the positive pressure reduce / eliminate overspray / misting ? Also the exhaust is there a noticeable smell from the vapours and enough to annoy neighbours . I’m looking at a similar setup though based on your info looking at a 10 ins fan Paul
-
All Esnipe bids entered at 5 secs to go . Boot plate sold for £48 with 3 bids at 5 secs to go so highest bidder won the auction Paul
-
Hi Ian , suggest signing up to Esnipe or similar . They do the bidding in the final 5 secs , you pay a very small fee if you are successful Paul
-
I see the above Webasto sold for £770 Paul
-
Opinions please, what colour does this look like?.
Paul H replied to PeteH's topic in Bodywork & Fittings
Not sure the cap is colour coordinated as you have the colour details overlaid . I’ve used the same spray can and the door was sprayed with celly from a 5 litre can from the club shop ( 4 coats ) Paul
